Bunn smartwave 15-s-aps manual

Begin each brew cycle with a clean empty brew funnel. FIG 6 3. Maximum water on time is 5 minutes. Use the following steps when the setting is unknown. Place an empty funnel in the funnel rails and an empty server beneath the funnel. This represents the adjust mode "Brew Time" for the "A" brew switch. The display will then change to minutes-seconds. Page Deliming Bunn-O-Matic recommends deliming your coffee brewer periodically. The actual frequency of deliming de- pends on the mineral content of the water you use.

NOTE: In hard water areas, this may need to be done daily. It will help prevent liming problems in the brewer and takes less than a minute. Remove the brew funnel. Page Cover Removal Unplug the brewer and let it cool down before proceeding. Front Wrap: 1. Remove upper and lower screws on either side of front cover.

Loosen middle screw on either side of front cover. Pull front cover towards front of brewer. Top Cover: 1. Unplug the brewer and let it cool down before proceeding. Remove the front cover. Water Fitting. Funnel Type. Dispense Type. Faucet Location. Product Warranty. Machine Height. Machine Width. Machine Depth. Attention Orders can only be shipped in the United States.

For international orders please call us at 1 Dismiss. Edit address Use this address. Browse Equipment. Dispensed Beverages.

Popular Equipment Families. Channel Insights. Catalog Region. North America. United States Canada Mexico. Flush the water line and securely attach it to the adaptor elbow. CAUTION - The brewer must be disconnected from the power source throughout the initial set-up, except when specified in the instructions. Insert an empty funnel into the funnel rails. FIG 4.

Place an empty server under the funnel. For taller servers, lift up on the front of the booster plate, and slide. FIG 5. Connect the brewer to the power source. Water will flow into the tank and stop when the tank is filled to its capacity. Wait approximately twenty minutes for the water in the tank to heat to the proper temperature. Some water will drip from the funnel during this time; this is due to expansion and is normal part of setup.

Water volumes and flow settings have been preset at the factory. Refer to Adjustments Section of this manual to set brew volumes should the volume need to be increased or decreased. The brewer is now ready for use in accordance with the instructions for Coffee Brewing.

Welcome to ManualMachine. We have sent a verification link to to complete your registration. Log In Sign Up. Forgot password?

Enter your email address and check your inbox. Please check your email for further instructions. Enter a new password. Page 2 PN: Page 3 Page 4 Plumbing Hook-Up 1. Turn on the water supply.